RFQ Checklist
To evaluate a custom stamping project accurately, send as much of the following as you have. Nothing here is compulsory — but each item you leave out is a question we have to answer by assumption, and an assumption in the quotation becomes a change order later. MOQ, tolerance and production timing are assessed per drawing, not from a standard table.
The six things that decide the price
- Part drawing, sample photos or a physical sample. The drawing revision is the document production runs against. If you are still on revision A and expect to release B, say so — tooling built to A will need modifying.
- Material and thickness. Grade and gauge set the die clearance, the bend radius and the press. “Steel” is not enough: Q235, SPCC and 304 behave differently in the same die.
- Surface finish. Zinc plating, powder coating or electrophoresis — with the coating thickness or colour standard where it matters. Plating also adds lead time and can change final dimensions.
- Quantity, annual demand or release quantity. This decides whether a single-stage die, a progressive die or press-brake bending is the sensible route. A price without a quantity is a guess.
- Critical dimensions and fit requirements. Mark the features that must hold — a bearing seat, a sliding fit, a hole used for alignment. Unmarked dimensions are treated as general tolerance.
- Target delivery date and destination country. The date decides whether the job is scheduled normally or expedited; the destination decides packing and shipping documents.
Drawing details worth checking before you send
Most delays we see come from drawings that are complete enough to look finished but not complete enough to manufacture. Before sending, check that the drawing carries:
- Material grade and thickness, stated on the drawing rather than in the email
- General tolerance block, plus individual tolerances on the features that matter
- Bend radii and bend angles, including which way each bend runs
- Burr direction or a maximum burr height, if the part is handled or visible
- Finish specification with the acceptance method — coating thickness, colour standard, or salt-spray duration
- Datum references, so inspection results and your incoming inspection agree on what is being measured from
- The revision number and date, on the drawing itself
If a feature is not decided yet, mark it as open. An open item is easier to close before tooling than to discover at sample approval.
What happens after you send
- Drawing review. We check geometry, material, thickness, feature feasibility and finish, and list anything that needs clarification.
- Process and tooling route. Single-stage die, progressive die or press-brake bending, with the reason for the choice.
- Quotation. Unit price at the quantities you asked about, tooling cost, sample timing, production lead time and the inspection scope — in writing.
- Sample. Small-batch samples within 7 days of confirmed requirements, with a dimensional report against the marked features.
- Approval and production. Production runs in 15–25 days after sample approval, packed and documented as agreed.
Our confirmed capabilities
- Established in 2011, located in Liaocheng, Shandong, China
- Stamping, bending and deep drawing processes
- 30–400T stamping presses, material from 0.5 mm to 10 mm
- Q235, SPCC, 304 stainless, copper and aluminium as regular materials
- ISO 9001 quality management system; we are not IATF 16949 certified
- Small-batch custom samples within 7 days after drawings and requirements are confirmed
- Target export markets: Malaysia, Vietnam and Thailand
Evaluated per project, not published as a blanket figure
Tolerance, monthly capacity, regular production lead time and MOQ depend on the part drawing and requirements. We confirm them in the quotation instead of publishing figures that would not survive contact with your part. Monthly capacity is approximately 100 tons, subject to product mix.
Send your project
Email the drawing and the information above to robert@hmstamping.com, or send it on WhatsApp at +86 132 1096 8646. If you would rather use a form, the quote request page accepts attachments. Either route reaches the same review.
Metal stamping capabilities · Materials and finishing · Stamping FAQ
KEEP READING
