
Drawing first
The revision that controls the part decides everything else — tool, process, price.
HARMONYOS · ABOUT
Harmonyos Metal Stamping has stamped brackets, plates and formed parts in Liaocheng, Shandong since 2011. ISO 9001 quality system, 30–400 T presses, 0.5–10 mm stock — quoted against your drawing revision, not from a catalogue.





We do not sell a product range. Every part we make starts as someone else’s drawing — a bracket that has to fit an existing assembly, a plate that has to locate a sensor, a clip that has to hold a given load. The job is to make that drawing repeatably, at the quantity and price agreed.
That is why the first conversation is about the drawing, not the price. Revision, material grade, thickness, the dimensions that control fit and whether the part gets plated afterwards — those five answers decide the tool, the process and the quote.
Production runs on 30–400 T presses in 0.5–10 mm cold rolled steel, stainless, aluminium and copper alloys. First-off parts are sent for approval before the run, and the inspection records agreed with the quote travel with the shipment.
We export to buyers in Europe, North America and Asia. If you need company registration, ISO 9001 certificate or equipment lists for supplier approval, ask — they are provided as documents, not as claims on a web page.
How a part moves through the workshop — material in, parts out.
Coil or sheet arrives with its mill certificate. Grade and thickness are checked against the drawing before anything is cut.
The die goes on the press and the first parts are formed. Bend angles, hole positions and burr height are checked against the drawing.
Parts from the new tool are measured, recorded and sent for your approval. Nothing runs in volume until that approval is in writing.
The batch runs against the approved revision, with in-process checks at the interval agreed in the quote.
Parts are counted, identified by part number and revision, packed as agreed and shipped with the inspection records.

The revision that controls the part decides everything else — tool, process, price.

Stamping, bending or drawing is chosen for the geometry, not for what is convenient.

Mill certificates and dimension reports are provided as documents, not as marketing claims.

Brackets, plates and clips stamped to your drawing revision.

Multi-station dies for repeat volumes, with piercing and forming in one pass.

Cups, housings and drawn shells, where draw ratio decides feasibility.

Dies designed, built and maintained in our own workshop.

Press-brake bending, formed profiles and welded sheet parts.

Flat blanks, profiles and cut-outs before forming.
Inspection scope is agreed with the quote. We state which dimensions get measured, how often, and in what format the results are recorded — so acceptance is a comparison against an agreed document, not an opinion at delivery.
Our quality system is ISO 9001. We do not claim IATF 16949, PPAP Level 3 or a published PPM figure, because we do not hold or publish them.
LET’S TALK ABOUT YOUR PROJECT
Attach the STEP file and the dimensioned PDF, then state material, thickness, quantity, finish and delivery destination. Feasibility, price and lead time are confirmed after review.
KEEP READING