Products
Harmonyos Metal Stamping supplies custom steel brackets and stamped metal parts made to customer drawings for export customers in Malaysia, Vietnam and Thailand. Parts run on 30–400T presses in Q235 carbon steel, SPCC cold-rolled sheet, 304 stainless steel, copper and aluminium, in thicknesses from 0.5 mm to 10 mm.

Every part starts from your drawing revision. We review geometry, material, thickness, hole pattern, bend sequence and finish before quoting, so the price you receive reflects a process that can actually hold the features you have drawn.
Product families
The families below cover most of what we stamp. Each page explains the geometry it suits and what is worth settling on the drawing before a quote.
- U brackets — channel and U-formed brackets where slot width and wall parallelism decide whether the part fits.
- L brackets — right-angle brackets where bend allowance and hole spacing decide whether the assembly closes.
- Mounting plates — flat plates with punched hole patterns held to datum-referenced tolerances.
- Stamped clips — retaining and spring clips where the working load sets the material and temper.
- Zinc plated brackets — brackets supplied plated for indoor and sheltered outdoor service.
- Steel brackets — the general bracket range, made to drawing in carbon and stainless steel.
- Custom metal stamping parts — parts that do not fit a standard family, including progressive-die work.
Processes behind the parts
Most brackets need two or more operations, and the sequence affects both tolerance and tooling cost:
- Metal stamping — blanking, piercing and forming, single-stage or progressive.
- Bending and sheet fabrication — press-brake work for low volume, and formed profiles the die cannot reach.
- Deep drawing — cups, housings and drawn shells, where the draw ratio decides feasibility.
- Materials and finishing — zinc plating, powder coating, electrophoresis and deburring.
Tooling is designed, built and maintained in our own workshop. That keeps sample iterations short: a drawing change that would mean a new supplier and a new tool elsewhere usually means a die modification here, which we can quote and schedule directly.
Choosing between families
The family is normally decided by the mating part rather than by the process. A bracket that locates a shaft needs a controlled slot; a bracket that carries a panel needs flatness and hole position; a clip needs the right temper more than it needs a tight tolerance. If your part sits between two families, send the drawing — the quotation will state which route we would use and why.
Specification summary
- Materials: Q235 carbon steel, SPCC cold-rolled steel, 304 stainless steel, copper, aluminium
- Thickness: 0.5 mm to 10 mm, confirmed per drawing
- Presses: 30T to 400T
- Finishes: electrolytic zinc plating, powder coating, electrophoresis, deburring
- Samples: small-batch custom samples within 7 days of confirmed requirements
- Production: 15–25 days after sample approval
- Monthly capacity: approximately 100 tons, subject to product mix
- Quality system: ISO 9001, in place since the company was established in 2011
Request a quote
Send the drawing revision, material and thickness, surface finish, quantity or annual demand, critical tolerances and target delivery date. If a requirement is still open, say so — we would rather confirm it before pricing than discover it at sample approval.
Request a quote · See what to include in an RFQ · Read the stamping FAQ
KEEP READING
