CAPABILITIES

Four processes, chosen by the drawing.

Stamping, bending, deep drawing and inspection. Each page covers the geometry it suits, the materials it works in, and what to settle on the drawing before a quote.

AI concept illustration of a precision metal stamping stamped housing and drive shaft

Choosing between the four processes

Most enquiries arrive as a drawing and a question: can this be stamped, and at what cost? The process is usually settled by three features rather than by the industry.

  • Depth relative to width. A shallow form is a stamping or a bend; a deep shell is a drawing job, and the draw ratio decides whether it needs one stage or several.
  • Volume against tooling. A single-stage die is a modest one-time cost and suits low to medium volume. A progressive die costs more but recovers it at repeat volume, because piercing and forming happen in one pass.
  • Features that must hold. If a hole has to align with a mating part after forming, the order of operations matters as much as the process. Piercing after bending and bending after piercing do not give the same result.

When a part sits between two routes, the quotation should say which one we would use and what the other would cost. That comparison is usually more useful than a single figure, because it shows where the price comes from.

If the geometry is not fixed yet, the die readiness guide covers what to settle before tooling, and the prototype comparison covers which process produces the evidence you need at sample stage.

◌

LET’S TALK ABOUT YOUR PART

Request a quote

Share your drawing, material and quantity.

Request for quotation

    By submitting this form you agree to be contacted about your enquiry.

    Custom stamping parts made to drawingRequest a quoteWhatsApp
    Export support for customers in Malaysia, Vietnam and Thailand · See what to send for a quote